The right terminal
Depending on the type of processing, the appropriate clamp must be available. if you use a traditional metal vice you can use it as long as you cover the jaws with PVC or with aluminum plates to not mark the wood at the point of grip.
Sergeants and clamps
Thanks to the particular type of clamping they are very quick and practical to use. The jaws are protected by plastic parts to avoid marking the wood. There are several measures on the market from a few centimeters up to two meters.
Clamps for frames
They allow the perpendicularity to be maintained and are therefore useful for creating frames and frames.
Quick-clamping clamps
Thanks to their shape, the eccentric lever produced holds the pieces in position and they are applied and removed very quickly.
"C" terminals
Normally they are smaller than the sergeants. They create a sturdy fastening but it is necessary to apply soft material to the jaws so as not to damage the surfaces.
Clamping terminals
They lock and indicate exactly where to drill to insert the joining pins.
Superlab
Multiple clamp with independent jaws equipped with quick locking adjustable with three degrees of tension.
Belt clamps
They consist of a strip of plastic material and movable jaws. The tape is tensioned and clamps the jaws around the piece without damaging it.
Bench vice
Existing of different types in metal, the typical one of the carpenter is a wood and hothouse against the bank with a screw mechanism.
U jumper
It is a particular "U" shaped nail that is placed in the head to block the attacks.
